Precision Control Systems DryIR 6030 - Manual (Page 11)

Model 6030 Dry IR Drying System Instruction Manual
Note: The Model 6030 will not operate unless a transport signal is supplied to the interlock
circuit.
Typically, an interlock cable is supplied from the transport and is connected on top of the blower
housing, near the ON/OFF switch.
WARNING!
• Disconnect the power to the heater module before proceeding.
To connect the interlock to the transport:
1. Remove the gray connector from the top of the unit.
2. The white insert can be removed from the housing by loosening the 4 screws that
secure it into the housing.
3. Route the wiring through the wiring gland in the housing.
4. The interlock wiring is connected to pins 1 and 4. To prevent the heater module
from running when the transport is stopped, the transport interlock power source
needs to be off when the transport is stopped.
5. Reassemble the connector and tighten the wiring gland.
Note: After completely installing the Model 6030, please ensure the stability of
the overall assembly.
Figure 3-2
7