beautypg.com

Introduction – Precision Control Systems 915 User Manual

Page 4

background image

Page 1 of 21

Introduction

General Description


The Model 915 power control system is a complete power control “solution” featuring a number
of elements integrated into a single, ready-to-install package. The Model 915 is a single-phase
power control system available in a variety of configurations from 120 to 480 volts and rated at
20-, 40-, or 70-amps. These systems are ideally
suited for many industrial power control
applications and have been specifically
optimized for use with Research Inc. infrared
heating systems.














Standard Features


Standard features include:

• Local 10 turn potentiometer with digital dial for precise manual control of load voltage.

• Remote control capability with a 0-5 VDC or 0-20 mA signal.

• Heater power switch with remote interlocks. The load voltage may be enabled or

disabled without turning off the main discount switch.

• Heater ON/OFF switch controls an AC contactor to remove power from the SCR

controller and the load.

• Cooling power switch to control air or water cooling flow.

• Cooling flow interlock contacts. Low cooling flow turns off the heater contactor.

• Heater over temperature contacts. Heater over temperature condition turns off the

heater contactor.

• Indicators lights for heater on, cooling on, heater over temperature, optional

temperature controller alarm and lamp-out alarm.

• Fail safe operation of the heater contactor. The contactor will not automatically re-

energize after a power failure, or an alarm condition that shuts down the heater.

• Programmable Logic Controller for operating and alarm logic control.

Section 1