Precision Control Systems ChamberIR E4 - Manual (Page 12)

Page 11 of 19
Installation
The following paragraphs describe mounting information, power connections, cooling water
connections and lamp installation.
Mounting Information -
Fasten the Model E4 to a sturdy support bracket via the 4 ¼-20NC x .37 inch deep threaded
holes on the side of the reflector block. Center the unit so that specimens will be located in the
focal axis. Physical dimensions for all units are listed in table 4-1, Dimensions A and B.
Table 4-1
Model Number Dimension A
(inches)
Dimension B
(inches)
E4-2 2.50 ---
E4-5 5.50 3.0
E4-6 7.40 3.0
E4-10 10.50 5.0
E4-16 16.50 5.0
E4-25 25.50 5.0
Note: The E4-02 has only two ¼-20 x .37 holes that are 1” apart, centered 1.25” from the edge of the
reflector
Section 4