Precision Control Systems 5620 - Manual (Page 10)

Page 10 of 14
11B
Connecting the LOAD and Line Wires
1. Pass the power source wire through the right lower strain relief clamp, and connect the
wires to terminals labeled: LINE 1, LINE 2 and GROUND.
2. Tighten the screws on the strain relief clamps to secure the wires.
Figure 3-2 Location of LINE, LOAD and GROUND terminals
CAUTION!
Line 2 must be neutral for all 120V
installations.
WARNING!
Never operate the controller without proper
GROUND wiring.