NSi Industries DZS200BP - Manual (Page 9)

If an offset to sunrise time is required, press
HOUR and MIN. Offset can be set to 4 hours and
59 minutes max. Press EVENT to select + or –
and then press ENTER.
NOTE: A + sign will turn load OFF that many
hours and/or minutes after sunrise. A - sign will
turn load OFF that many hours and/or minutes
before sunrise.
8.2 ASTRONOMIC ON AND TIME OFF
Set astronomic ON per sections 8.0 and 8.1
TIME OFF:
Press MODE until “sch01” appears. Press ENTER
until a blank schedule appears then press SELCT
to select channel 1 or 2. Press HOUR and MIN to
set desired OFF time. Press SELCT to select
desired days, holiday and/or seasons and then
press ENTER.
8.3 TIME ON AND ASTRONOMIC OFF
Press MODE until “sch01” appears. Press ENTER
until a blank schedule appears then press SELCT
to select channel 1 or 2. Press HOUR, MIN and
EVENT to set desired ON time. Press SELCT to
select desired days, holiday and/or seasons and
then press ENTER.
ASTRO OFF:
Set astronomic OFF per sections 8.0 and 8.1
9.0 REVIEW, MODIFY AND DELETE
Press MODE to advance to any of the following
MODES:
1. CLOCK MODE: Press HOUR and MIN to mod-
ify existing settings. Press ENTER.
2. DATE MODE: Press MONTH, DATE and YEAR
to modify existing settings. Press ENTER. DAY
is automatically adjusted.
3. DST Daylight Saving Time: To review press
ENTER. To modify press MONTH, DATE and
DAY to change existing setting.Press ENTER.
4. SEASON MODE: Press ENTER to advance to
desired season. Press MONTH and DATE to
10
Press MONTH and DATE to set holiday 1 and
then press ENTER. The display will show:
To delete any holiday press DEL and press
ENTER.
NOTE:
a.
A total of 24 holidays can be set, all following
the same schedule.
b. For any holiday to be used, the MONTH and
DATE must be preset.
6.0 TO SET SIGNAL DURATION FOR
EACH CHANNEL
Press MODE until display shows:
Press SELCT to select channel 1 or 2. Press
EVENT/SEC to set desired signal duration (1 to
99 seconds each), and then press ENTER.
NOTE:
a.
Use the procedure above to set for Signal 2 or
to set signal duration for CH2, if desired.
b. Each channel can have two independent
durations (sig 1 and sig 2).
7.0 SCHEDULE SET MODE
Press MODE until display shows:
Press SELCT to select channel 1 or 2.
7
DTS200B - DZS200BP 3/8/07 9:20 AM Page 17