NSi Industries DPC201 - Manual (Page 5)

3
AT POWER UP:
When powering up the unit for the first time, 12:00 will flash on the
display. NOTE: Allow 1-2 minutes for the supercap to charge before any
display is shown. Press reset button after 2 minutes if screen is blank
(see
image on page 1)
.
Press the MODE key
1.0 CLOCK MODE
Press HOUR and MIN to advance to the present hour and
minutes. Check AM/PM, and press ENTER.
2.0 DATE MODE
If you are setting for the first time, display will show:
Press MONTH, DATE, and YEAR key to advance to the
desired month, date and year, then press ENTER.
NOTE: The day of the week will be automatically set once the date
is set.
3.0 DAYLIGHT SAVING TIME MODE
After setting or modifying the date, display will show:
For standard USA daylight savings (DSt), press MODE then
go to step 4.0. If daylight saving time (DSt) is NOT required,
press DEL display will show:
Press the ENTER key.
NOTE: AFTER MAKING ANY CHANGES TO THE PROGRAM, PRESS MODE
TO GO TO AUTO (AUTOMATIC) MODE AND THEN PRESS EVENT TO
UPDATE THE LOAD STATUS.
PROGRAMMING YOUR
DPC201
ON
OFF
To modify standard USA
daylight savings dates.
Call technical support
888-500-4598
AM
CLK
SU
DATE