NSi Industries DGM100A - Manual (Page 10)

8
Press the EVENT key once (or twice for two circuit
units) to activate current schedule then EVENT key
again to return to AUTO mode .
7.0 REVIEW, MODIFY AND DELETE
Press MODE to advance to any of the following
MODES:
1 . AUTO MODE: In this automatic mode, the unit will
execute the scheduled programs . Time, day, seconds
and load status are displayed . If today is a
programmed holiday, the day of the week will flash .
OVERRIDE IN AUTO MODE: The load status of the
channel can be manually changed by pressing the
OVRD key (or OVR1 and OVR2 key for DG200A) .
The unit will stay in this position until the next
scheduled event . A flashing LCD load indication (ON,
OFF) shows the status was changed by the override
not a scheduled event .
2 . MAN MODE: In this manual mode, the unit will
ignore the schedule programs . Time, day, seconds
and load status are displayed . If today is a
programmed holiday, the day of the week will flash .
This can be used as a VACATION SETTING to keep
load off while away . Use override to set to OFF
position .
OVERRIDE IN MAN MODE: The load status of the
channel can be manually changed by pressing the
OVRD key (or OVR1 and OVR2 key for DG200A) .
The unit will stay in this position until OVRD is pressed
again . A flashing LCD load indication (ON, OFF)
shows the status was changed by the override not a
scheduled event .
3 . CLOCK MODE: Press HOUR and MIN to modify
existing settings . Press ENTER to save changes .