Martel Electronics T140 Series - Manual (Page 6)

• When servicing the calibrator, use only
specified replacement parts.
• To avoid false readings, which could lead to
possible personal injury, replace the battery
as soon as the battery indicator appears.
3. Set-up
Before beginning, become familiar with the
keypad layout and the configuration of the
pressure manifold connections. Note the
location of the high and low pressure ports as
indicated by the label on the rear of the
calibrator.
Install the 9V alkaline battery by removing the
two retaining screws securing the battery
compartment door. Once the battery is in place
secure the battery compartment door by
tightening the retaining screws. The T140 is
now ready for operation.
4. Media Compatibility
The T-140 low pressure models (10”, 200”, 30
PSI and 100 PSI) can work with liquids and
gases that are compatible with the following
wetted materials:
• Silicon
• RTV
• Glass
• Ceramic
• Buna-N
The high pressure versions of the T-140 (300
PSI, 3,000 PSI) can work with any liquid or gas
compatible with 316 stainless steel and nickel
plated brass.
4