Autostart AS-1452v - Manual (Page 6)

P. 6 User Guide
7. Remove the key: the engine will go on running.
8. Exit the vehicle and close the door.
9. Press the
TRUNK
button until the system is armed (the doors will be locked if remote
door lock is installed).
If the pre-programmed run time expires or if the user shuts down the engine by remote
control, the vehicle will get in Ready Mode.
Caution: Do not leave children or pets unattended in a car in Idle Mode.
Valet Modes
When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine
from being remote started accidentally.
Valet Mode using the Valet Button
(If installed)
To put the system into Valet Mode:
1. Turn the key to the
IGNITION ON (RUN)
position.
2. Press (for at least 1 second) and release the Valet Button. The LED will come
ON
.
To take the system out of Valet Mode:
1. Turn the key to the
IGNITION ON (RUN)
position.
2. Press (for at least 1 second) and release the Valet Button. The LED will go
OUT
.
The Valet button can only be used if the vehicle keys are in the
IGNITION ON (RUN)
position.
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine
from being accidentally started by remote control.
To enter Valet Mode
• With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
• The Parking Light will flash 3 times indicating the Module is now in Valet Mode.
The LED will turn
ON
solid.
To exit Valet Mode
• With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
• The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn
OFF
.
Panic Mode
Note: Panic Mode can only be activated if the horn has been adequately configured
by your installer.
In an emergency situation, you can activate Panic Mode using the
LOCK
or
UNLOCK
button.
This will:
• shut down the engine,
• unlock the doors (with the
UNLOCK button),
• or lock the doors (with the
LOCK button),
• disarm the Starter Kill and
• activate the horn for 25 sec.
Note: See the description of the Starter Kill option later in this Guide.
To activate Panic Mode:
• Press and hold the
UNLOCK
button for approximately 3 sec. until the sound signal starts
and the parking lights flash: This will unlock the doors before the sound signal starts.