Autostart AS-1452v User Manual

Page 4

P. 4

User Guide

Arming the Starter Kill
If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm

automatically) or in Passive Mode (will arm automatically).
• To disarm the Starter Kill in Active or Passive Mode, press the

UNLOCK

button on the trans-

mitter. The parking lights will flash twice. (If Remote Door Locks were installed, this will

also unlock the doors.) In Passive Mode, the system will automatically rearm 1 or 3

minutes after the doors were unlocked.

• To arm the Starter Kill in Active or Passive Mode, press and hold the

LOCK

button on the

transmitter. The parking lights will flash once. (If Remote Door Locks were installed, this

will also lock the doors). In Passive Mode, the system will automatically arm 1 or 3 minutes

after the engine is shut down.

Remote starting Your Vehicle

If your vehicle has an automatic transmission, simply press the

START

button to remote start

or stop your vehicle. Skip the next steps on to “Remote starting”.
Warning: If you vehicle has an automatic transmission and the parking lights flash 15 times

after pressing the

START

button, the parking brake is connected to ground. It is imperative

that you see your installer and have him disconnect the wire.

Setting Your Vehicle into Ready Mode

If your vehicle has a manual transmission you must read the following indications. In order

to start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to

Ready Mode, it cannot remote start the vehicle.

Please note that Ready Mode can be enabled by the remote or the handbrake,

depending on the option that was selected by your installer. Therefore, you must

follow the appropriate procedure between the two described below in order to set your

vehicle into Ready Mode.

Once the system is set to Ready Mode, the vehicle can be remote started and stopped at

any time. The system will exit Ready Mode if a door, the hood or the trunk is opened, if the

brake pedal is pressed, if the parking brake is disengaged or if the ignition key is turned to

the

IGNITION ON (RUN)

position.

To set the system to Ready Mode:

If Ready Mode is enabled by remote

If Ready Mode is enabled by handbrake

Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the neutral
position.

With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.

With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.

Within 20 sec. of engaging the parking brake,
press and hold

LOCK

UNLOCK

START/STOP

on the transmitter.

The parking lights will flash 3 times
quickly and remain lit.

Remove the key: the engine will continue running.

Exit the vehicle and close all doors, hood and trunk.