Alpine CDA-7969R - Manual (Page 11)

9
-EN
Adjusting the built-in Audio
Processor
You can change High Pass Filter, Low Pass Filter,
and Sub Woofer Phase on this unit, so that you
can create your favorite sound effects.
1
Press and hold the A. PROC button for at least 3
seconds to enter Adjust Mode.
2
Within 5 seconds, press the DN g or f UP
button repeatedly to select the desired parameter.
→ HPF → LPF∗ → SUB-W∗
∗ When the subwoofer is turned OFF by using
this unit, LPF and phase are deactivated.
3
Rotate the Audio Control knob to select the
desired setting.
1. HPF (Setting the High Pass Filter):
→ OFF ←→ 63Hz ←→ 80Hz ←→ 100Hz ←
→ 200Hz ←→ 160Hz ←→ 125Hz ←
Outputs all frequencies higher than that selected
according to your preference.
2. LPF (Setting the Low Pass Filter):
→ OFF ←→ 63Hz ←→ 80Hz ←→ 100Hz ←
→ 200Hz ←→ 160Hz ←→ 125Hz ←
Outputs all frequencies lower than that selected
according to your preference.
(Only available when using the subwoofer output
from this unit.)
3. SUB-W (Change the Subwoofer Phase):
NORMAL ↔ REVERS
You can change the subwoofer phase.
(Only available when using the subwoofer output
from this unit.)
NOTES
• If the battery is disconnected, all settings return to
factory default.
• If no buttons are pressed within 5 seconds, the setup
menu returns to the normal audio display.
Selecting DHE Mode
Using digital signal processing technology, DHE
(Digital Harmonics Enhancer) operates on
harmonic components which determine tone and
coloration of the musical instruments. The
process operates independently on individual
frequency bands, so each instrument or vocal will
be distinct. Play back clarity is enhanced to
compensate for road noises which would normally
detract from the listener's enjoyment.
1
Press and hold the DHE button for at least 2
seconds to switch to the DHE mode.
2
Press the Preset buttons (F1 through F6)
within 10 seconds to select the desired mode.
F1: OFF (NON EFFECT)
F2: Beat MAX (DHE1)
Strong Low Frequency emphasis.
F3: Lyric MAX (DHE2)
Strong vocal emphasis.
F4: Beat MIX (DHE3)
Good balance between bass and vocals.
F5: Lyric MIX (DHE4)
Slight vocal emphasis.
F6: Phase MIX (DHE5)
Enlivens any genre.
3
Press the F button within 10 seconds to select
the desired mode.
POWER mode:
Any of the DHE effects can be modified using
the Power Mode. Enhanced bass and high
frequencies will be added to the selected DHE
effect.
FINE mode:
Selecting the DHE fine mode will emphasize the
vocal/chorus sustain for clear sound
reproduction.
PWR – FINE mode:
Both the POWER mode and the FINE mode will
be activated simultaneously.
→ POWER mode → FINE mode
PWR – FINE mode
←