Safety instructions – KROHNE SMARTSENS ORP 8150 Ex EN User Manual

Page 3

SAFETY INSTRUCTIONS

SMARTSENS ORP 8150

www.krohne.com

07/2014 - 4003048502 - MA SMARTSENS ORP 8150 R02 en

Safety instructions

1.1 General notes

This additional Ex instruction applies to explosion-protected versions of the sensors with the
marking II 1 G. It completes the standard documentation for non-explosion protected versions.

The information given in this instruction contains only the data relevant to explosion protection.
The technical details given in the standard documentation for the non-explosion protected
versions remain unchanged unless they will be excluded or replaced by this instruction.

1.2 EC conformity

The manufacturer declares with the EC declaration of conformity on his own responsibility
conformity with the protection goals of directive 94/9/EC for use in hazardous areas with gas.
Conformity with harmonised standards was checked in accordance with EN 60079-0:2012 and
EN 60079-11:2012.

The EC declaration of conformity is based on the EC type examination certificate of the
Physikalisch Technische Bundesanstalt (PTB):

You can download the EC Type Examination Certificate from the manufacturer's website.

1.3 Approval according to the IECEx scheme

Conformity with IECEx standards was tested in accordance with the IECEx Certification Scheme
for Explosive Atmospheres acc. to IEC 60079-0:2011 and IEC 60079-11:2012. The number of the
IEC certificate is:

You can download the IEC certificate from the manufacturer's website.

1.4 Safety instructions

Assembly, installation, start-up and maintenance may only be performed by personnel trained in
explosion protection!

PTB 13 ATEX 2018 X

IECEx PTB 13.0036 X

CAUTION!
Should operating conditions and locations require the observance of further standards,
guidelines and laws, this is the responsibility of the operator and/or those commissioned by him.

.book Page 3 Friday, July 11, 2014 2:56 PM