KROHNE ACM 500 EN - Manual (Page 7)

02/2013 ACM 500 7
2.1 Connection plan:
2.2 Start-up
•
Check that the display unit is correctly aligned; it should where possible be perpendicular to
the direction of flow (for pipes).
•
Check the leak-tightness at the sleeve.
•
Make sure that the cable glands are tight and the M12 plugs are properly bolted.
•
Without selection of the measuring range and without parameter assignment by user, the
device after connection to the supply voltage will operate in the measuring range 0...200 mS,
0...150°C und 2%/K.
•
Make sure that the housing cover is screwed down tight.
2.3 Operator control
•
The back-lit LC display generally indicates conductivity in millisiemens per centimetre
(mS/cm) and temperature in degrees Celsius (°C).
•
For simple parameterization of the measuring ranges and temperature coefficients, use the
rotary button with touch function (jog shuttle). Turn it to the right (or left) to move forwards
(backwards) in the menu structure and increase (decrease) parameter values. Press the
button to get to the submenu or setting menu for the respective parameter, or back again
simultaneously with confirmation of the input.