KROHNE BM 102 HART - Manual (Page 8)

BM102 Remote Operation - HC 275 / AMS
Dev.-Rev. EC, DD-Rev. 01
© 2000 KROHNE SA 26103 Romans (France) Page 8
device is in search mode or if it is executing a function.
Not implemented Appears if the command sent to the device is not implemented in
the device.
First Parameter too high
(first member of the couple too high)
First Parameter too low
(first member of the couple too low)
Second Parameter too high
(second member of the couple too high)
Second Parameter too low
(second member of the couple too low)
Some parameters are handled in couples. When a member of a
couple is written, the other member is also written. When one of
this message occurs, one of the member of the couple is incorrect.
These couples are :
Tank height / Probe length
Dead zone / Detection delay
Threshold value / Threshold distance
Optional unit name / Optional unit factor
Offset of measure / Period of measure
Electronics Calspeed / mechanical calspeed
Epsilon R / “Set value” of Electronic offset