KROHNE BM 102 HART - Manual (Page 11)

BM102 Remote Operation - HC 275 / AMS
Dev.-Rev. EC, DD-Rev. 01
© 2000 KROHNE SA 26103 Romans (France) Page 11
7 Attachment B
Designations:
Measurements
•
Level
•
Distance
•
Volume/Mass/Flow
•
Ullage Volume/Mass/Flow
Process Variables
Status
-----------------------------------
Diagnostics and Test
Calibrate
-----------------------------------
Re-start BM102
-----------------------------------
Master reset
Reset user EEPROM
Reset factory EEPROM
-----------------------------------
Change Maintenance Access
Get Specialist Authorization
-----------------------------------
Audit Trail
Drawing Notes ...
Help ...
-----------------------------------
Clear Offline Configuration
Compare Configurations
Configuration Properties
Overview
•
Primary variable out of limits
•
Non-primary variable out of limits
•
Primary variable analog output saturated
•
Primary variable analog output fixed
•
Cold start
•
Configuration changed
•
Field device malfunction
Hardware :
•
Error: EEPROM problem
•
Error: RAM problem
•
Error: Incorrect checksum ROM
•
Error: Analog to Digital converter
does not work correctly
•
Error: Gains do not work correctly
•
Error: Electronic offset out of limits
Voltage :
•
Error: Incorrect value for +3.3 volts
•
Error: Incorrect value for -3.3 volts
•
Error: Incorrect value for VCO1
voltage
•
Error: Incorrect value for VCO2
voltage
- subsists and is displayed only when the Strap Table exists
- refer to the next page
Fatal Errors
Param :
•
Error: Incorrect checksum
for bank0 user
•
Error: Incorrect checksum
for bank0 factory
•
Error: Incorrect checksum
for bank1 user
•
Error: Incorrect checksum
for bank1 factory
Pulses :
•
Delay out of limits
•
Reference not found
•
Flange not found
•
Error : FPGA
Reprogramming
•
Error : FPGA Parity
•
Full tank
•
Empty tank
•
Level lost
Warnings
BM102 Menu Tree AMS
KROHNE BM102 45ec01
Analog Output
•
Analog Output Value
•
PV Percent of Range
Calibration Management
-----------------------------------
D/A trim
Apply values
-----------------------------------
Watch Pulses
Voltage Values
Problem History
Status History
-----------------------------------
Distance input
Search Probe Length
Auto Calcul Offset
Audio Signal offset
-----------------------------------
Strap table input
Strap table suppress
Loop test