KROHNE BM 702 HART User Manual
Page 8
KROHNE Messtechnik GmbH & Co. KG · Ludwig-Krohne-Str. 5
! D-47058 Duisburg
8/10
Tel.: 0203-301 0
! Fax: 0203-301 389 · e-mail: [email protected]
Remote Operation Instructions BM 70 A/P, BM 700, BM 702 HART
Attachment B
Process Variables
Status
Scan Device
-----------------------------------
Diagnostics and Test
Calibrate
-----------------------------------
Master reset
Entry Code
Service Code
-----------------------------------
Audit Trail
Drawing Notes ...
Help ...
-----------------------------------
Clear Offline Configuration
Compare Configurations
Configuration Properties
Overview
•
Primary variable out of limits
•
Non-primary variable out of limits
•
Primary variable analog output saturated
•
Primary variable analog output fixed
•
Cold start
•
Configuration changed
•
Field device malfunction
Opt
– Optional, depends on device implementation;
– refer to the next page.
Designations:
•
Level
•
Distance
•
Conversion
•
Reflection
Opt
•
Analog Output
•
PV Percent of Range
•
Relay State
Opt
Hardware Failures
•
CPU error
•
ROM checksum error
•
RAM read/write error
•
Interrupt Controller error
•
Timer error
•
EEPROM Error
Critical
Runtime/Measuring Errors
•
Signal down
•
No measurement value
•
VCO error
Warnings
•
Signal low
•
Signal too strong
•
Poor spectrum
•
Sweep low
•
Empty Spectrum bad
•
Measured value old
Informational
Miscellaneous
•
Tank bottom
•
Measurement frozen
•
Tank overfilled
•
Relay in test mode
Opt
•
Current set to error
•
Relay set to error
Opt
Configuration Errors
•
Calibration data error
•
Configuration error
BM 70 A/P /700 /702 Menu Tree AMS
KROHNE BM 70 A/P /700 /702 45f90b02