KROHNE IFC 090 Converter PROFIBUS PA EN - Manual (Page 3)

Supplementary Documentation IFC 090, IFC 090 i with PROFIBUS-PA
General
These Instructions are supplementary to the “Installation and Operating Instructions IFC 090 K / F“ dated 12/96. The
details given there, in particular the Safety Information, are valid and should be observed. These Supplementary
Instructions provide only additional information for device operation and connection to a PROFIBUS-PA fieldbus.
Attention: Please set the controller to manual mode before changing parameters of the IFC 090.
Items included with supply
In addition to the standard scope of supply, these Supplementary Instructions for the IFC 090 with PROFIBUS-PA
interface, plus a diskette with all available GSD files of KROHNE devices.
Software history
KROHNE Messtechnik GmbH & Co. KG · Ludwig-Krohne-Str. 5 D-47058 Duisburg 3/7
Tel.: 0203-301 309 Fax: 0203-301389 · e-mail: [email protected]
Control system (PLC)
Class 1 master
Segment
coupler/link
Analog I/O module
PROFIBUS-PA
4-20 mA
HART device
Power
Supply
PROFIBUS-PA
Segment
coupler/link
PROFIBUS-DP, up to 12 Mbit/s
Engineering or operation
control tool
Class 2 master
K R O H N E
1 2 3 4 5 6
K R O H N E
1 2 3 4 5 6
1000 900 800 700 600 500 400 300 200
kg/h
100 RP
KROHN E H250 SN 586 677/ 01-0 3 MC H2 50/RR/ M9/K2/ ESK-Z C K2 5.2 1 .457 1 F CI V 25 1 .4571 MD 1997 C2H50H D 0.93 kg/ l V 2.5 mPa.s T 23.5 C P 0.4 MPa FIA 1025
kg 0 3 6 8 7 2
Issued Signal converter User program Instructions
month/year Hardware Firmware Hard-
ware
Operating
system
Soft-
ware Device User
program
09/98 PROFIBU
S-PA
Module
1.00 12/96+Supplement
01/99
05/99 PROFIBU
S-PA
Module
2.00/99050
5 PC Windows
95, 98, NT
4.0
PDM
³ V
4.1.1
12/96+Supplement
05/99 + 08/99, 03/00
07/00 PROFIBU
S-PA
Module
2.00/ PC Windows
95, 98, NT
4.0 PDM
³ V
4.1.1
12/96+Supplement
07/00
1. PROFIBUS-PA
The above diagram shows a typical instrumentation with PROFIBUS-PA devices in hazardous and non-hazardous
locations, including connection of conventional devices (e.g. with 4-20mA signals) to the PROFIBUS-PA. The
PROFIBUS-PA is normally connected to a segment coupler which, among other things, carries out conversion to the
PROFIBUS-DP. Here, it needs to be noted in particular that the segment coupler is normally set to a fixed baud rate
on the DP side.