KROHNE OPTITEMP LCD-H20 EN - Manual (Page 6)

3
INSTALLATION
6
OPTITEMP LCD-H20
www.krohne.com 11/2011 - 4001594702 - AD OPTITEMP LCD-H20 R02 en
Installation
3.1 Mounting in the connection head
3.2 Configuration
3.2.1 Programming procedure
Programmed using the 3 pushbuttons located on the bottom of the indicator. The middle key is
the enter key (F), the two outer keys with the up and down arrows are used to select various
parameters. Positioning of the Keys on page 9.
Figure 3-1: Installing the loop powered indicator into the BUZ-HW connection head
1 Polycarbonate window
2 Loop powered indicator LCD-H20
3 Mounting kit KDST1
4 M20 x 1.5
Key Function
F F F F Calling up programming mode.
Switching between parameter and set value.
Save values.
Decrease by one digit
Selecting or setting a parameter.
Increase by one digit.
Selecting or setting a parameter.
+ Exit programming mode.
Cancel.
.book Page 6 Monday, November 21, 2011 10:31 AM