KROHNE OPTITEMP TT 11 C-R EN - Manual (Page 5)

SAFETY INSTRUCTIONS
1
5
OPTITEMP TT 11 C/R
www.krohne.com 05/2011 - 4000752902 - MA OPTITEMP TT 11 C/R R02 en
Safety instructions
1.1 Intended use
The manufacturer has constructed these transmitters only for temperature measurements with
single resistance thermometers of the type Pt100 and Pt1000. The main field of application are
building services applications.
1.2 Certifications
1.2.1 EC directive compliance
The device fulfils all applicable statutory requirements of the following EC directives:
• EMC Directive 2004/108/EC, harmonized standard EN 61326-1:2006
• CE Directive 93/68/EEC
The manufacturer certifies successful testing of the product by applying the CE marking.
DANGER!
Neither operate this transmitter in potentially explosive areas, nor connect it to a sensor located
in a potentially explosive area! Otherwise the transmitter might cause an explosion that can
result in fatal injuries!
DANGER!
Responsibility for the correct use of the devices with special regard to suitability, intended use
and the field of application lies solely with the operator. To avoid any kind of incorrect use, also
note the information in the chapter "Device description".
DANGER!
The transmitters do not contain any serviceable parts inside. Always send defective devices to
the manufacturer or the local distributor for repair or exchange. If this is the case, attach a clear
description of the malfunction for warranty claims.
INFORMATION!
The manufacturer is not liable for any damage resulting from improper use or use for other than
the intended purpose. To avoid any kind of incorrect use, also note the information in the chapter
"Device description"!
CE marking
.book Page 5 Friday, May 6, 2011 10:52 AM