KROHNE OPTITEMP TT 11 C-R EN - Manual (Page 15)

INSTALLATION
3
15
OPTITEMP TT 11 C/R
www.krohne.com 05/2011 - 4000752902 - MA OPTITEMP TT 11 C/R R02 en
3.4 Rail-mount transmitter
1 Hook the upper groove of the transmitter onto the rail.
2 Press the lower part of the transmitter against the rail.
i When you hear a "click" from the snap fastener, the transmitter is fixed onto the rail
(drawing in the centre).
3 To remove the transmitter, use a small screwdriver to push the snap fastener downwards.
4 Carefully move the lower part of the transmitter in the forward direction and then upwards.
DANGER!
Neither operate this transmitter in potentially explosive areas, nor connect it to a sensor located
in a potentially explosive area! Otherwise the transmitter might cause an explosion that can
result in fatal injuries!
CAUTION!
The manufacturer has developed the in-head transmitter for an operating temperature range of
-20...+70°C / -4...+158°F. To avoid destruction or damage of the device, always assure that the
operating temperature does not exceed the permissible range.
INFORMATION!
The rail-mount transmitter is intended for installation on a rail according to DIN 50022.
Figure 3-2: Installation of the rail-mount version
.book Page 15 Friday, May 6, 2011 10:52 AM