KROHNE OPTISWITCH 3300C NAMUR EN - Manual (Page 20)

6 Set up
6.1 General
The numbers in brackets refer to the following illustrations.
On the electronics module you will find the following indicating
and adjustment elements:
l
Potentiometer for switching point adaptation (1)
l
DIL switch for mode adjustment - min./max. (2)
l
Simulation key (3)
l
Signal lamp (6)
6.2 Adjustment elements
Simulation
NAMUR IEC 60947-5-6
VB60N
4
5
6
1
2
3
Fig. 13: Oscillator WE60N - NAMUR output
1 Potentiometer for switching point adaptation
2 DIL switch for characteristics reversal
3 Simulation key
4 Ground terminal
5 Screwed terminals
6 Control lamp
You can adapt the switching point to the solid with the
potentiometer. The switching point is preset and covered by a
label. It must only be modified in special cases.
By default, the potentiometer of OPTISWITCH 3300 C is set to
the right stop (>0.02 g/cm³ or >0.0008 lbs/in³). In case of very
Function/Configuration
Switching point adaptation (1)
20 OPTISWITCH 3300 C - with NAMUR output
Set up
31358
-EN
-060830