KROHNE OPTISWITCH 3000C Relay EN - Manual (Page 17)

6 Set up
6.1 General
The numbers in brackets refer to the following illustrations.
On the electronics module you will find the following indicating
and adjustment elements:
l
DIL switch for mode adjustment - min./max. (1)
l
Signal lamp (4)
Note:
As a rule, always set the mode with mode switch (1) before
starting the setup of OPTISWITCH 3000 C. The switching
output will change if you set the mode switch (1) afterwards.
This could possibly trigger other connected instruments or
devices.
6.2 Adjustment elements
2
3
4
1
Fig. 10: Oscillator - Relay output
1 DIL switch for mode adjustment
2 Ground terminal
3 Screwed terminals
4 Control lamp
With the mode adjustment (min./max.) you can change the
switching condition of the relay. You can set the required mode
Function/Configuration
Mode adjustment (1)
OPTISWITCH 3000 C - with relay output 17
Set up
30059
-EN
-060830