KROHNE UFM 800 EN - Manual (Page 3)

Installation and operating instructions UFM 800 W / UFM 800 C 3 12/2000
1.0 Description of the installation
The supplied installation is basically the same as the UFM 400F (single beam SB) or the UFM 500F (double beam DB). The difference is that
the sensors are welded in an existing steel pipe. Because wet calibration is impossible, the primary constant (GK) will be calculated from the
geometry. If a reference value of the flow rate is available, the installation can be calibrated on site.
– 2 FS 500W sensors
– 2 sensor supports
– 2 protected sensors cables (length depending on outer diameter)
– 1 square pipe with 2 threaded holes
– 1 connection box, incl. print, gasket, screws and cover
– 1 connection cable MR02 between the connection box on the pipe and the signal converter (length 5-50 m)
– UFC 500F signal converter with wall mounting kit
– 1 tube of acoustic coupling grease
– 1 bottle Silicon oil AK 2000
1.1 Material delivered for SB
– 4 FS 500W sensors
– 4 sensor supports
– 4 protected sensors cables (length depending on outer diameter)
– 1 square pipe with 4 threaded holes
– 1 connection box, incl. print, gasket, screws and cover
– 1 connection cable MR02 between the connection box on the pipe and the signal converter (length 5-50 m)
– UFC 500F signal converter with wall mounting kit
– 1 tube of acoustic coupling grease
– 1 bottle Silicon oil AK 2000
1.2 Material delivered for DB