KANOMAX S352-10 Piezobalace Dust Monitor - Manual (Page 6)

2
1.2 System Settings
Settings of Piezobalance Dust Monitor.
1) Communication Settings
Screen of
the Piezobalance Dust Monitor
Description of Operation
When high voltage is NOT being supplied, press
“MENU”, and the screen shown on the left will be
displayed.
Select “COMMUNICATION” by using ▲ and ▼.
Press “SET” to proceed to the communication settings
screen.
Set the communication baud rate by using ▲ and ▼.
To enter the settings, press “SET” at item 2.
The baud rate can be selected from the following by
using ▲ and ▼.
19200 9600 4800
Operation Precautions
- By selecting a COM port, the software will automatically configure the baud rate settings.
- When a computer is connected to the instrument, communication is possible without using the screen of the
instrument .
In this case, the instrument screen must be set to the “MENU” screen.
- Do NOT use the software when the instrument is performing a measurement. There may be problems
transferring data if communications occur while the instrument is measuring.
MENU 1.NORMAL
2.SAMPLING
TIME
3.DATA OUTPUT
4.PRINT OUTPUT
5. DATA CLEAR
6.TIME ADJUST
7.COMMUNICATION
COMMUNICATION
1.BAUDRATE
19200
2.SAVE INFO