KANOMAX 3910 Portable Particle Counter Software Manual User Manual

Page 27

6. Measuring Software

6.5. Remote Measurement

NOTE: The instrument must be placed in “REMOTE MODE” when running this program. (Please refer to the
instrument manual for further directions.)

Both the PC running the software and the Airborne Particle Counter must be connected to the LAN and
properly configured in order to access the Airborne Particle Counter remotely via PC.

6.5.1. Start/End Measurement

1) To Start a Measurement

Click [Measurement] -> [Measurement] or the

icon to start a measurement.

If the LAN is not connected properly or the HOST cannot be found after one
minute, the error message shown on the right will be displayed.

If a LAN connection error occurs, confirm the settings on the
Airborne Particle Counter and the software settings (Refer to
6.4.1. LAN settings).

2) To End a Measurement

Click [Measurement] -> [Measurement Stop] or the
icon. A dialog box appears asking “Are you sure
you want to stop measurement?” Click [Yes] to stop
measurement. Data collected up to the point the
measurement was stopped will be stored.

3) To Cancel Remote Mode

Click [Measurement] -> [Remote Mode Cancel] to
cancel the remote mode on the instrument.

NOTE: If you cancel the remote mode on the instrument,
you will need to place the instrument back in remote
mode before you can begin another measurement (Please
refer to the instrument manual for further directions).