HT instruments XL424 - Manual (Page 17)

XL423 - XL424
EN - 16
10.3 ACCESSORIES
Description Code
Adhesive Velcro 50 x 70 cm
VELCRO
Set of 2 Black/Blue alligator clips (XL423 only) KITXL423C
Set of 4 Black/Grey/Red/Blue alligator clips (XL424 only) KITXL424C
Carrying bag BORSA2000
Management software DATALINK
Serial cable C2004
Batteries GP15AU
User’s manual
YAMUM0010HT0
11 SERVICE
11.1 WARRANTY CONDITIONS
This equipment is guaranteed against any material fault or manufacturer’s defect, in
accordance with the general conditions of sale. During the warranty period (one year),
faulty parts may be replaced, with the manufacturer reserving the right to decide either to
repair or replace the product.
In the event of returning the equipment to the after-sales service or to a regional branch,
the outward transport is to the charge of the customer. The returning must be agreed in
advance with the supplier or local distributor. A report indicating the reasons for returning
and defects detected must accompany the instrument.
The manufacturer will not be responsible for any damage against persons or things.
The warranty doesn’t apply to the following cases:
• Accessories and batteries (not covered by warranty).
• Improper use of the equipment or combination of the instrument with incompatible
equipment.
• Damages caused by incorrect shipping procedures.
• Damages caused by repair/service trials of unauthorized people.
• Modifications to the equipment without explicit authorization of our Technical Dept.
• Adaptation to a particular application not provided for by the definition of the equipment
or by the instruction manual.
The contents of this manual may not be reproduced in any form whatsoever without our
agreement.
Our products are patented. The logotypes are registered. We reserve the right to
modify characteristics and prices as part of technological developments which
might require them.
11.2 AFTER-SALE SERVICE
If the equipment doesn’t work properly, before contacting our Service Dept. please test the
battery condition and replace them whether necessary. If the problem persists check if
your operating procedure agrees with the one described in this manual.
In the event of returning the equipment to the after-sales service or to a regional branch,
the outward transport is to the charge of the customer. The returning must be agreed in
advance with the supplier or local distributor. A report indicating the reasons for returning
and defects detected must accompany the instrument. The manufacturer will not be
responsible for any damage against persons or things.