HT instruments HT9021 - Manual (Page 14)

HT9021
EN - 13
4.3.6. Temperature measurement
CAUTION
Do not allow the temperature sensor to contact a surface that is energized
above 30 V RMS or 60 V DC, such voltages pose a shock hazard
Fig. 8: Taking Temperature measurement
1. Rotate the switch on Temp position
2. Pushing MODE key and select the kind of measure. “°C” or “°K” symbols are shown at
display respectively for Celsius or Farheneit temperature measurements
3. Insert the type K bead probe in V Ω
CAP Temp and COM inputs terminals using
the standard adapter and observing the correct polarity (see Fig. 8). The temperature
value is shown at display
4. For HOLD and MAX/MIN features please refer to § 4.2