HT instruments HT9 - Manual (Page 11)

HT6-HT8-HT9
EN - 10
5.4. CONTINUITY TEST
WARNING
Before carrying out any continuity test, check that the resistance to be
measured is not live. Failure to respect this prescription may seriously harm
the operator.
Fig. 6: Continuity test
1. Connect the measuring leads L1 and L2 to the object
to be tested (see Fig. 6).
2. The instrument switches on automatically together with
led RX (see Fig. 2 – no. 6) and the buzzer sounds
continuously in case the result of the continuity test is
positive.
3. The continuity test is active if the resistance to be
tested is lower than 500k .
In case of measurements in environments with poor light,
press the Torch button (see Fig. : 1 – no. 7) to activate the
white LED pointer.