Detcon 1610A-FB - Manual (Page 4)

Shipping address: 3200 A-1 Research Forest Dr., The Woodlands, TX 77381
Mailing address: P.O. Box 8067, The Woodlands, Texas 77387-8067 ❏ Phone: (281) 367-4100 ❏ Fax: (281) 292-2860
PART # DESCRIPTION
5026 Multiple alarm relay circuit
3622 250 watt, 24 vdc switcher power supply
0224 Gold plated jumper tab
2812 28 vdc lamp for power and disable switch
0295 5 amp micro fuse
0301 4 amp 3AG fuse
3218 Power switch
3218 Disable switch
2806 Green switch cap
2807 Red switch cap
3280 Fuse holder
❏
1.9 SPARE PARTS
❏
1.8 WARRANTY
Detcon inc., as manufacturer, warrants under
intended normal use each new Model 1610A-FB
control enclosure to be free from defects in
material and workmanship for a period of one year from the date of shipment to the original purchaser.
All warranties and service policies are FOB the
Detcon Inc. facility located in the Woodlands, Texas.
(4) Disconnect the 2 pin plug on the right of the
power supply.
(5) Remove the 3 screws from the bracket that
holds the power supply to the controller mother
board.
(6) Lift the power supply out of the enclosure
and remove the five wires from the two terminal
strips located on the power supply. (7) Replace by reversing the above steps.
Note: Be sure to re-connect the wires properly.
Connect AC to the 3 pin terminal strip; Pin 3 =
GROUND, Pin 2 = L1, Pin 1 = L2. Connect DC to
the Stand up terminals (+ is red; - is black); Pin
numbers are screened on the power supply PCB.