Delmhorst Instrument TechCheck - Manual (Page 5)

Copyright  2008, Delmhorst Instrument Co.
Page 5 of 15
TO POWER THE METER ON:
To turn the meter on, press and hold the center HOLD (SELECT) KEY for approx. 2 seconds.
The meter will start in PIN mode.
METER USE
TO TAKE PIN READINGS:
1. Press the PIN ( ï) button to enter the pin mode.
2. The meter will display the PIN mode screen, as shown below:
3. Push the contact pins into material to be tested. Any Delmhorst electrode may also be
used in PIN mode by simply attaching it to the connector next to the contact pins.
4. The unit will read %MC on a wood scale between 6% and 60%. At elevated wood
temperatures, a reading above 30 percent is valid if the temperature-corrected reading