Delmhorst Instrument ProScan - Manual (Page 9)

8
• Using ProScan In A Water Damage Restoration Or Mold Remediation
Job:
ProScan is a useful tool in identifying moisture in walls, ceilings and floors in a
water restoration or mold remediation. In order to establish pre-loss
conditions, find an area of the building that was not damaged and take
several readings on various materials. This will provide you with a “dry
standard” or target moisture levels when drying damaged areas.
Take several readings on each wall. Pay special attention near the base,
around doorjambs, electrical and plumbing fixtures, and other places where
water may have entered. Use the meter continuously during the drying
process to monitor drying progress.
• Testing EIFS (Exterior Insulation and Finishing System):
Moisture intrusion problems in EIFS (synthetic stucco) stem from leaking
window and door frames, improper use of or lack of sealant, and faulty
installation of flashing. f you suspect a problem conduct a visual inspection.
Look for gaps around windows, doors, air conditioning units, light fixtures,
hose bibs, dryer vents and other areas of potential penetration. Also look for
visible signs of water damage. If you believe a problem exists, use ProScan
as a quick scanning tool to determine the general location of the moisture.
Then use a pin- type meter to better identify exact problem areas and depth
of moisture intrusion.
CARE OF YOUR METER:
• Store the meter in a clean, dry place. The protective carrying case provided is
an ideal storage place when the meter is not in use.
• Change the 9-Volt battery as needed. Continued use with a low battery may
cause the meter to go out of calibration. Use only Duracell, Eveready, or other
battery brand designed for digital electronics.
• Clean the meter with any biodegradable cleaner. Use the cleaner sparingly
and on external parts only.
• Remove the battery if the meter will not be used for one month or longer.