DeFelsko PosiTector SPG v.1.1 Full Manual - Manual (Page 33)

30
Temperature Temperature
Operating range: +32° to +120°F (0 to +50°C)
The PosiTector SPG compensates automatically for
temperature. Allow a few minutes for the probe to reach ambient
temperature before measuring.
Discard the first measurement taken in a notably different
temperature condition. When measuring surfaces much hotter or
colder than ambient, lift the probe at least 6 inches (15cm) and
allow 1 second off the surface between measurements.
Technical Data Technical Data
Range: 0 – 500 µm (0 – 20 mils)
Accuracy: ± (5 µm + 5%) of reading
± (0.2 mils + 5%) of reading
Resolution: 1 µm (0.1 mils)
Probe tip: 60° angle with a 50µm radius tip
Measurement speed: >40 readings per minute
Weight: 140 g (4.9 oz.) without batteries
Dimensions: 137x61x28 mm (5.4" x 2.4" x 1.1")
Troubleshooting Troubleshooting
Most conditions can be cleared with a Hard Reset (see pg. 9). If
not, visit our Service & Support page for information on sending
your Gage to us for a no charge evaluation.
See: http://www.defelsko.com/service
Thickness readings are inconsistent:
- Probe tip may be damaged, scratched or worn
Gage will not print to the Bluetooth wireless printer:
- Ensure the gage has been paired for use with the printer and
the Gage menu option Connect > Bluetooth > Stream box is
ticked.
- Check printer batteries. Switch it off and then on again.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.