DeFelsko PosiTector 6000 v.6.2 for Basic (1) and Standard (2) models User Manual
Page 3

3
Quick S
Quick S
t
t
art
art
1.Separate probe models - remove red protective
rubber cap if supplied. Built-in probe models -
remove Gage from protective rubber holster.
2.Turn Gage on with any button.
3.Place the probe FLAT on the surface to be
measured. HOLD STEADY. When a valid
measurement is calculated, the Gage BEEPS
twice, the bi-color LED blinks green, and the
measurement is displayed.
4.Lift probe AT LEAST 2 INCHES (5cm) from the
surface between measurements - OR - leave probe
on the surface in the same location for continuous
measurements every 2 seconds. Do not drag the
probe sideways on the surface.
Golden Rule
Golden Rule
Measure your uncoated part first! This quick zero-
check determines if a calibration adjustment is
needed for your substrate. (See pg.5)
Next, lay the included plastic shims onto the bare
surface and measure them individually to ensure the
Gage can measure a known thickness within
tolerance.