Catskill Craftsmen 64228 - Manual (Page 6)

STEP 3
A. Assemble Knife Rack by inserting four brass colored 1 1/4” #8
Screws through the countersunk (reamed out) holes in the Knife
Rack into the pilot holes in the long edges of the Knife Rack
Sides. Tighten untill Seated. Sides will be flush with the bottom
of the face leaving a space at the top.
ILLUSTRATION 3
A. Attach the Drawer Back to the Drawer Sides with four 1 1/4” #8 screws. There are left and
right sides. Make sure the slots that run the length of the Sides are aligned with the slot in the Drawer
Back to accept the Drawer Bottom.
B. Slide in Drawer Bottom, best side up, to inside of drawer.
NOTE: On the 64228 the Drawer Back only has one hole and uses 1 1/2” #8 screws to attach as in
illustration 4B.
C. Take the 2 bastion posts, align the threaded end of the posts with the post holes located
near the ends of the inside of the Drawer Front. Tighten posts down until the solid shaft of the posts
hits the wood. Back post out until the hole/screwdriver slot in end of post is parallel and in direct line
with the long edges of the Drawer Front.
D. Insert the barrel nuts into the nut access holes on the inside of the Drawer Sides with the
threaded ends of the nuts facing out. Take the Drawer Front and carefully insert the posts into the ends
of the Drawer Sides, through the sides of the nuts until seated. Push nut snug up against the wood in
the nut access hole toward the inside of Drawer Front. Hole should be slightly off-center toward the
Drawer Front. Insert the set screw and tighten down. The ends of the sides should be tight against the
inside Drawer Front.
E. Attach the drawer handles with 1” Truss head machine screws.
F. Attach the drawer glides (left and right) to the Drawer Sides using two 5/8” #5 screws per
side. Wheels go toward Drawer Back and are up. The end with no wheels should touch the Drawer
Front.
FOR TIPS ON HOW THE BASTION SYSTEM WORKS SEE LAST PAGE!
STEP 4
ILLUSTRATION 4A ILLUSTRATION 4B
Model 64220 Model 64228