Catskill Craftsmen 64228 - Manual (Page 10)

STEP 9
A. Stick magnet to magnet plate on a door.
B. With all other doors open, close the door. The magnet should be positioned over the wooden block
on the bottom of the top front brace. Hold the magnet in place with your thumb, and open the door.
The magnet will be in the correct position on the block.
C. Secure magnet with the two round head screws in the magnet packet. Center screws in the slot in
the magnet . This will allow adjustment later, if needed.
D. Repeat these steps for all the doors.
ILLUSTRATION 9
ILLUSTRATION 10
STEP 10
A. Insert and tap caster sockets
with hammer until the teeth grab
the wood. DON’T POUND
SOCKET FLAT OR CASTER
SHAFT WILL NOT ENTER.
B. Insert casters and seat by
pushing straight downward with
heel of your hand, or tap into place
with a hammer. Don’t be afraid to
give them a good downward whack
on the solid metal part of the
caster!
C. Locking wheels usually go on
front.
No pilot holes as softwood.