Catskill Craftsmen 54238 - Manual (Page 8)

STEP 6
A. Lay Back Panel flat on a smooth surface with holes up.
B. Attach Side Panels with 1 3/4” machine screws (bolts) and hex nuts. After inserting bolts thru the
holes in the Side Panels, thru the holes in the long edges of the Back Panel, place a hex nut on the
tip of your finger, align nut with bolt and tighten. Back panel has 1 1/4” space at the top.
C. Look ahead to step 7 which shows side panels attached to back panel.
D. Insert 1” pins into back panel as shown.
1 3/4” Bolts
1” Pin
1 3/4” Bolts
1” Pin
Nut
Nut
Note: Wheel on glide is
to the front of the unit
1 3/4” Bolts
1” Pin
1 3/4” Bolts
1” Pin
Nut
Nut
Note: Wheel on glide is
to the front of the unit
STEP 7
Bottom Brace
Assembly
A. Secure bottom brace
with 1 3/4” bolts/nuts as
shown.
B. Insert 1” pins into
the side panels as shown.