Catskill Craftsmen 54238 - Manual (Page 4)

STEP 1
A. Tap/insert ONE 1 1/2” pin into each end of all the doors. DON’T OVERDRIVE PINS! Pins should
stick up about 1/2” when seated.
STEP 3
Assemble Spice Rack
Insert retainer
rods into holes
Fasten Shelves with
1 1/4” Phillips Flat Head
#8 Screw (Bronze)
Pilot holes in shelves
go toward back
B. Attach the
magnet plate
(may be stuck
to magnet!) with
the 1/2” #4 screw
to the top of the
doors. Bumps go
toward the wood.
C. Attach door
handles with 7/8”
truss head machine
screws.
STEP 2
A. Take the 2 front braces and tap/insert one 3/4” steel pin into each end of both braces until seated.
About 3/8” will stick out when seated. OK if loose.
B. Insert two 1” pins in bottom brace as shown.
7/8” Truss Head Screw
1/2” #4 Flat Head Screw
5/8” #8
1” Pin
3/4” Pin
The counter sunk hole
goes out so the bumps
go toward the wood.
1 1/2” Pin
Flush at bottom, space at top to clear magnet
Not used Not used
(Included in magnet pack)
Top Front Brace
Insert
Bottom Front Brace