Step 5 – Catskill Craftsmen 1481 User Manual

Page 8

Bastion Post & Pin Assembly

STEP 5

4 Legs, 4 Front/Back Braces, 3 Mid/Bot Side Braces, 2 Doors, 1 Back Panel, 2 Top Side

Braces, 2 Glide Support Braces

Tap 3/4” Pins into the ends of all the Braces and the back panel using a hammer, it is ok if pins

are loose. Tap the 1 1/2” Pins into the ends of the Doors with a hammer. The Back Right Leg and the

Front Left Leg are identical, as are the Back Left Leg and the Front Right Leg. Group them together

so that you have 2 sets of opposite legs, one set for the front, one set for the back. For the Front

Legs, screw bastion posts into the third hole from the top and the bottom hole as illustrated. When

seated, holes in posts should be perpendicular with the long edge of the leg. For the Back Legs,

screw bastion posts into the top hole and in the bottom hole as illustrated. The bottom of the leg is the

end with the large hole in it. Tap 1 1/2” pins into the holes the near the bottom end. For the middle

holes you have to choose the height where you want the middle shelf, then tap in 1 1/2” pins.

1 1/2” Pin

Bastion Post

Front Legs

Back Legs

1/2” #4

Attach magnet plate so that the bumps face the wood

FLL

BRL

FRL

BLL

1 1/2” Steel Pin

Choose from the three holes, the

height where you want the middle shelf.

This can always be changed later.

3/4” Pin

Four of this brace

Two of this brace