Ab c, Default settings for new zealand, Preparation – Allied Telesis 210 User Manual
Page 3: Connecting the ar210
Default Settings for New Zealand
VPI
:
0
(by default, do not change)
VCI
:
100
(by default, do not change)
Authentication
:
PPP using PAP
Connenction Type
:
PPPoA Routed
(by default, do not change)
Encapsulation
:
Vc-Mux
(by default, do not change)
DSL
Configuration
:
G.DMT/Multi (by default, do not change)
Preparation
Before you start, make sure your computer meets the minimum requirement
below:
Computer Requirements :
>
USB installed on your PC/MAC
>
TCP/IP protocol is installed
Note :
-
For USB connection type for standalone computers, you must install USB driver to
get it done. The driver can be found on the enclosed CDROM.
Details from your ISP :
>
Login name and password
e.g.
>
DNS server(s) ip address(s)
e.g. 203.96.91.1
Connecting the AR210
For a step by step guide Refer to the Installation guide on Pages 8-10 for a PC :
>
Connect the telephone cable (provided) to the AR210 then connect the other end to the
ADSL port that telecom has installed. Do not connect the ADSL Router through a
Microfilter.
>
Connect the USB (cable provided) to your PC’s USB port and the other end to the
AR210.
A
B
C