Aposonic A-S3216T3 - Manual (Page 19)

DVR User Manual
13
3 Basic Function Instruction
3.1 Startup & Shutdown
Please make sure all the connections are done properly before you power on the unit. Proper startup and shutdown are crucial
to expanding the life of your DVR.
3.1.1 Startup
Step1: Connect with the source power.
Step2: The device will boot and the power LED would turn blue.
Step3 A WIZZARD window will be pop-up and show some information about time zone
，time setup，network configuration,
record configuration and disk management. User can setup here and refer to the concrete setup steps from the corresponding
chapters. If users don‟t want to setup Wizard, please click Exit button to exit.
Note: This DVR can only display options on either VGA/HDMI monitor or CVBS monitor at a given point of time. If you have
connected CVBS monitor, you will get a tip that says
“Long press „ESC‟ or „Stop‟ to display the menu”. That is to say, long
press ESC/Stop key can switch the output between CVBS and VGA/HDMI.
3.1.2 Shutdown
You can shut down the device by using IR remote controller and mouse.
By IR remote controller:
Step1: Press Power button. This will bring up a shutdown window. The unit will shut down by clicking “OK” button.
Step2: Disconnect the power
By mouse:
Step1: Enter into Menu and select “Shut Down” icon. This will take you to a shutdown window.
Step2: Click OK. Then the unit will power off after a while.