WycoTool SELECT-Cycle Converter - Manual (Page 4)

wyco
THE WYCO TOOL
COMPANY
Form #W510 CPN
Printed in U.S.A. 8/05
P.O. Box 081580 Racine, Wisconsin 53408
8635 Washington Ave Racine, Wisconsin 53406
Telephone: (262) 639-6770 or 1-800-233-9926
Fax No: (262) 639-2023 or 1-888-992-6872
SYMPTOM
(GFI) Ground Fault
Interrupter repeatedly trips
Vibrators stop while
power is still applied to
converter and rotary
switch is not off
Vibrators do not come up
to full speed and converter
trips after 2 minutes
Fuses on converter input
have blown
POSSIBLE CAUSE
Short in wires between high
cycle head and switch
Short in internal high cycle
motor
Short in high cycle cord or plug
Internal drive has tripped
Some lower voltage power
sources cannot start two
vibrators at once
Excess current applied to
power drive
REMEDY
Remove head and check wires
for wear. Repair as required
Replace high cycle motor stator
assembly
Replace cord or plug
Unplug converter for two minutes
and plug back in to reset. If the
problem persists have error code
on drive checked by a qualified
electrician/personnel. Refer to
drive manual for resolution
Follow start up procedure in order
by powering drive and turning it to
desired speed before turning on
vibrators with the switch on the
vibrators
The drive will internally shut down
when most problems occur. If the
fuses blow it is an indication of a
serious problem and the converter
should be returned to the factory.
The high cycle vibrators should
also be thoroughly inspected
Troubleshooting Information
12
R
Manufacturers Limited Warranty
The WYCO Tool Company warrants that the products manufactured by it, when properly installed, used and maintained,
shall be free from defects in material or workmanship, and will perform according to the manufacturer’s specifications
under normal conditions, subject to the limitations stated in this Manufacturer’s Limited Warranty.
WYCO’s obligation under this warranty shall be limited to repairing or replacing the part or parts, or, at WYCO’s option,
the products which prove defective upon return to the manufacturer’s factory. Cost of transportation and other expenses
connected with replacing parts are not covered.
WYCO’s obligation under this Warranty is limited to a period of 18 months from the date of shipment, or 12 months
from the date of purchase by the first user of the product, whichever is longer.
Written authorization from WYCO is required before any product can be returned for warranty consideration.
WYCO is not liable for any consequential damages or any contingent liabilities arising out of the failure of product
manufactured by it, or any component part or accessory.
This Manufacturer’s Limited Warranty is in lieu of all other warranties. All other warranties, either express or implied,
arising by operation of law, course of dealing, usage of trade or otherwise are excluded.
No agent, representative or distributor has any authority to alter the terms of this warranty in any way
.
THERE ARE NO IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR PURPOSE.