WEN 4210 10 Variable Speed Drill Press - Manual (Page 13)

4212 WENPRODUCTS.COM 13
Assembly and adjustments
(continued)
Table adjustments
Raise or lower the table (Fig. 11)
1. Loosen the support lock handle (1) and turn the crank handle (2) until
the table is at the desired height.
2. Tighten the support lock handle (1) before drilling.
Rotate the table (Fig. 11)
1. Loosen the support lock handle (1) and turn the table around the
column to the desired position.
Note: The rack should rotate around the column with the table support bracket. If the rack binds and will not
rotate, slightly loosen the set screw in the rack collar.
2. Tighten the support lock before drilling.
Tilt the table (Fig. 12)
1. Loosen the bevel lock bolt (under table) with a suitable socket
wrench.
2. Tilt the table to the desired angle, using the bevel scale (1) as a basic
guide.
3. Re-tighten the bevel lock bolt.
4. To return the table to its original horizontal position, loosen the bevel
lock bolt.
5. Realign the table to the 0° setting on the bevel scale.
6. Tighten the bevel lock bolt with the wrench.
1 2
Fig. 11
Fig. 12
1