WEN 6510 oscillating spindle sander - Manual (Page 15)

Troubleshooting
1. Over time, if the performance of the tool diminishes, or it stops working completely, it may be
necessary to replace the Carbon Brushes (34) by removing the Brush Holder (33). This
procedure should be completed by a qualified technician. If the Carbon Brushes are not worn
down, try cleaning the Carbon Brush tips with an ink eraser.
2. If the Sanding sleeve stops rotating when you touch it or press the stock material against it, turn
off the machine at once. Unplug the machine and check to make sure that the Hex Nut (1) s
threaded on tight to the Spindle (55).
15