WEN 6510 oscillating spindle sander - Manual (Page 14)

Maintenance
WARNING: Turn the switch to the OFF position and unplug the power cord from the
electric outlet before adjusting or performing maintenance on the spindle sander.
Lubrication
Ball bearings are grease packed at the factory, and require no further lubrication. Use a spray
lubricant on all moving table parts to ensure smooth operation.
General Maintenance
Before each use, check for damaged, missing, or worn parts. Check for proper alignment of moving
parts, moving parts that are jammed, broken, or improperly mounted. If any of these conditions
exist, do not use the spindle sander until it is properly repaired or the parts are replaced.
Cleaning
Frequently blow or vacuum dust away from all sander parts and the motor housing.
Periodically remove the throat plate and lower washer from the spindle and remove any dust
accumulation in the throat plate area.
WARNING: Never use flammable or combustible solvents around tools. When servicing,
use only identical WEN ® replacement parts. Use of any other parts may create a hazard or cause
product failure.
14