WEN 3912 10 inch band saw - Manual (Page 11)

Assembly and adjustments (continued)
WARNING:Unplug the machine from the power source before assembling or
adjusting anything. Failure to comply may cause serious injury.
To Assemble the Stand(Figure 1)
1. Place the band saw (A) on its back either on the floor or (preferably) on a workbenchas
shown above.
2. Assemble the four legs (G) to the inside of the base of the band saw, securing each leg with
two carriage bolts (Q1), flat washers (R1) and nuts (S1). Only hand-tighten at this time.
3. Attach a long plate (J) to the rear legs as shown in Figure 1. Secure with 2 carriage bolts
(Q2), flat washers (R2), and nuts (S2). Only hand-tighten at this time.
4. Attach the remaining long plate to the front legs in the same manner described above, hand-
tightening only.
5. Attach two short plates (H) to the right legs and left legs in the same manner. Secure each
leg with 2 carriage bolts (Q3), flat washers (R3), and nuts (S3). Only hand-tighten at this
time.
6. Slip rubber feet (N) onto the ends of the stand legs.
7. Place the saw and stand upright on a level surface. Make sure that all four legs are
contacting the surface.
8. Tighten all nuts with a 13mm socket or wrench.
11