900w bridge saw – Vitrex 103500 User Manual

Page 7

Remove the cover retaining screws and take off

the blade guard.

The bridge saw comes with handles for ease of

moving the machine.

Whilst holding the shaft with the spanner wrench,

turn the blade retaining nut clockwise to release

using the hex wrench.
Ensure that the new blade is correctly seated

against the shaft and that the directional arrow

matches that on the blade guard. Replace the

flange and nut, taking care not to overtighten.
Rotate blade to ensure correct alignment.
Replace the blade guard and water tubes.

For transportation the saw between jobs, wheels

can be mounted at the top of the folded legs, just

below the angled stabilising bracket. The saw

can now be moved by lifting the handle at the

opposite end of the machine.

Note: Please clean the pump immediately after you stop

use. Otherwise the filter foam and the impeller could

be stuck by the dry debris. So you must replace the filter

foam or the pump.
1. Clean the pump

To clean the pump, remove the intake Cover, and

then take out of the filter foam and impeller cover.

Use a small brush or stream of water to remove any

debris on the foam and the impeller.
2. Replace the filter foam

To replace the filter foam, remove the intake cover,

then take out of the filter foam and put into a

new one.
Two replacement filter pads supplied with machine.

Moving the Bridge Saw

Transportation

Pump Maintenance

Tel: +44 (0) 1253 789180

900W Bridge Saw