Vitrex 103500 - Manual (Page 5)

04 05
Assembly & Operation Operating Instructions
Remove the saw from its carton, lay carefully on
its side.
Unfasten blade carriage retaining bolt.
Push the blade carriage to its furthest point away
from the operator. Place the tile in position on the
cutting table so that it rests against the measuring
scale and mitre guide.
Set the size of cut required on the measuring
scale and lock the mitre guide.
Switch on the machine.
Pull the blade carriage steadily towards you,
cutting through the tile. When the cut is complete,
switch off the machine, removing the cut tile
pieces and any debris.
Straight Cuts
Pull down the legs and fasten the four safety
brackets to them using the nuts
Make sure the wheels are tightened.
Ensure that the drain plug is in position, then fill
the water tray until the pump is almost sub-
merged. (approx. 10 litres). Check water level
regularly and top up as necessary.
Make sure you put safety catch across to keep
water tray in place.
Tel: +44 (0) 1253 789180 Tel: +44 (0) 1253 789180
900W Bridge Saw