USGlobalsat DG-200 Ver.1.1 - Manual (Page 7)

7
Chapter 2：Start to Use
DG-200 Operation
1. Press and hold the power button for three seconds to turn on DG-200. Then you would
see GPS LED on.
2. After getting GPS fix and starting to record traveled path, GPS LED would flash.
3. When DG-200 could get GPS fix, you could short click power button to save the
present location to inner memory flash. You could see memory LED flash once to
show the present location is saved. (You could not save location if it could not get
GPS fix.
DG-200 Power Button LED status after turning on device
DG-200 Power Off
Under power-on status, press and hold power button for three seconds to turn off device.
GPS LED would be off after device is powered off.
DG-200 Connection with PC
1. Connect DG-200 and PC by USB cable.
2. Turn on DG-200 PC Utility.
3. Run “PC Utility” program and you could use the functions of the program.