Triton FT5000 Installation Manual - Manual (Page 33)

3 3
I
NSTALLING
C
ABINET
T
HROUGH
W
ALL
O
PENING
1. Carefully inspect the unit for any
shipping damage and report any
damage immediately to the
shipping company. Refer to the
warranty information in the
operation or service manual (as
applicable) for information about
reporting shipping damage.
2. After unpacking the unit, move the
cabinet using the proper lifting/
moving device to the wall opening.
3. Slide the unit up to the opening
until the sleeve portion of the
cabinet is near the wall (Figure 1).
4. Measure the distance from the
bottom of the wall opening to the
bottom of the sleeve. This will be
the height requirement of the
“plinth”, if needed. Add an
additional 1/8” (3.175mm) to your
measurement for clearance (Figure
2).
Figure 1. Slide unit up to interior
wall.
Figure 2. Measure from bottom of
wall opening to bottom of sleeve.
*Important*
DO NOT install the control
panel fascia at this time.
Note
A “plinth” is a platform on which the
ATM rests or is secured. This plinth
enables the ATM to be installed at
the required height through the wall.
S
ITE
P
REPARATION
/I
NSTALLATION