Triton 9710 Series Quick Reference Guide - Manual (Page 2)

CASSETTE/DAY CLOSE F
1. SELECT DAY CLOSE OPTION. RECEIPT PRINTS. NOTE: IF ATM DAY CLOSE IS NOT PERFORMED AT SAME
TIME AS PROCESSOR, HOST SETTLEMENT AMOUNT MAY NOT MATCH TERMINAL SETTLEMENT AMOUNT
ON DAY CLOSE RECEIPT.
2. PLACE ATM IN SERVICE.
DAY CLOSE
CASSETTE CLOSE
JOURNAL G
ACCESS MANAGEMENT FUNCTIONS USING PROCEDURE AND SELECT THE JOURNAL OPTION. TO
PRINT THE JOURNAL SELECT THE PRINT JOURNAL OPTION. THIS WILL PRINT ALL RECORDS THAT HAVE
NOT BEEN AUDITED. THE RECORDS WILL BE MARKED. TO PRINT PREVIOUSLY AUDITED OR PRINTED JOUR-
NAL RECORDS, USE THE PRINT LAST X ENTRIES OPTION.
PRINT JOURNAL
CLEAR JOURNAL
SERVICE PROVIDER J
THIS AREA FOR SERVICE PROVIDER CONTACT INFORMATION:
1. GO TO MANAGEMENT FUNCTIONS USING PROCEDURE . SELECT CLOSE OPTION. CHOOSE CAS-
SETTE CLOSE. SELECT CASSETTE A. SELECT CASSETTE CLOSE. CASSETTE CLOSE RECEIPT PRINTS.
3. REMOVE CASSETTE. COUNT CASH. CASH IN CASSETTE (INCLUDING REJECT NOTES) SHOULD EQUAL
REMAINING AMOUNT VALUE ON RECEIPT.
4. LOAD CASSETTE, USING PROCEDURE . REPLACE CASSETTE. SELECT ENTER QTY. IN CASSETTE
FROM CLOSE MENU. ENTER NUMBER OF BILLS LOADED IN CASSETTE. PERFORM A TRIAL CASSETTE
CLOSE. KEEP RECEIPT AS RECORD OF BEGINNING CASSETTE BALANCE. PLACE ATM IN SERVICE.
ACCESS MANAGEMENT FUNCTIONS USING PROCEDURE AND SELECT THE JOURNAL OPTION. TO
CLEAR THE JOURNAL: SELECT THE CLEAR JOURNAL OPTION. THIS WILL AUDIT ALL UNPRINTED JOURNAL
RECORDS. AUDITED RECORDS WILL NOT BE PRINTED WHEN THE PRINT JOURNAL COMMAND IS USED.
2 5
REPLENISHING CASSETTES H
STEP ACTION
1
STEP ACTION
4
6 3
REMOVE NOTE CASSETTE.
LOAD NOTE CASSETTE WITH NOTES.
REMOVE REJECTED NOTES.
RELEASE PACKER PLATE.
LEVEL THE NOTE PILE.
REPLACE NOTE CASSETTE.
2
6
REPLACING RECEIPT PRINTER PAPER I
STEP ACTION
1
STEP ACTION
5
3
4
7
8
CUT REMAINING PAPER TO ALLOW
REMOVAL.
PRESS FEED BUTTON TO CLEAR PAPER
FROM PAPER PATH.
LIFT SPINDLE TO TAKE-OUT HOLE AND
REMOVE PAPER ROLL AND SPINDLE.
REMOVE SPINDLE FROM OLD PAPER ROLL.
PLACE SPINDLE IN NEW PAPER ROLL.
FEED END OF PAPER INTO FEED SLOT.
PLACE NEW PAPER ROLL ON BRACKET.
MAKE SURE PAPER FEEDS FROM BOTTOM!
PAPER WILL FEED AUTOMATICALLY.